Create the parametric solid model for the part shown in the picture below using SolidWorks software

Create the parametric solid model for the part shown in the picture below using SolidWorks software. Build the model in shown isometric position. Follow the parametric modelling rules taught in class. Fully constrain all your sketches. Create a Design Table, sort values, show two decimals of precision for all values. Create four different configurations of your choice, and test them. Leave part in default configuration, isometric view, zoom to fit. Units are mm, material is Aluminum. 
Important hints: • Dimension 68 mm is measured from the center of the cylinder to the bottom of the part • The top cylinder is longer than its supporting vertical wall, as visible in the picture 
Part: Hinge 
RIBS BOTH SIDES 
'11/4-,,,.. 50 

5 X 2.5 KEYSEAT 015 
NOTE 1: ROUNDS AND FILLETS ARE 3 MM